Economical, foldable (or somehow reducable for storage) tool to measure swingarm pivot to rear axle distance on each side for wheel alignment. Most versions are bulky and >$65.
Undertail that caters to extended bikes and increases the underseat volume to be able to install 2 batteries, or battery and datalogger or power commander, microtech, etc so that access to these items does not require extended tailsection removal.
The rear axle distance tool is something I have already done and just haven't finished the CAD, I guess I better get on the stick.
the undertail with space should be pretty easy to do with extended tails. How deep do you think i should make them since the wheel will be out? I'm thinking a dropped section directly under the normal hump area?
Guy
Actualy I was referring to directly behind the battery area. There is a cross bar on the subframe, but if it could somehow be worked around it would be great. I believe the Motorhead undertails had greater volume in this area.
As for the laptop table, I received mine and noticed it was a little "shakey". Not that it would have had any issues holding a laptop, but I slightly modified mine as follows:
I used a small dead blow hammer and tightened the gap up where the top interfaces with the flat portion on the stand. I also wrapped a few wraps of electrical taps around the vertical tube at the lower triangulated leg brace interface. possible making the hole in the lower "triangle" smaller would tighten up the "play" a bit. Also, a few of the rivets were fairly loose. I tightened them up a bit with a pair of chanel locks.
Perhaps a mounting kit for extended tails woudldbe a good product for Tiger Racing as well. Always needed and could likely be made very cheaply.
Maybe an AMS 1000 mount on top of the triple clamps. I copied ZX-Alan's for mine. Two simple strips with a few holes and bends.
John