Here's the results of todays dyno session,Akro race carbon fiber single exhaust,my bike rolled in with the ti-Force map as there is no Akro map and made 180 hp,then after messaging the map I picked up substantial gains low,mid and high my bike made 185.5 hp and 107 ft lb of torque,that's alot of torque and I was very happy with the number then my friend put his 08 on the dyno next with a yosh single carbon pipe and made 188 hp and 106 ft lb of torque,I was in disbelief that the yosh put out that kind of hp,even though his bike tickled 106 ft lbs my bike had more torque through out the rev range,but other than that the bike were pretty much identical,I was impressed with the numbers the bikes put out.I would like to thank LEWE JOLLY @ LEWES CYCLE SHOP in MANCHESTER,CT. for doing a very thorough job in tuning both of our bikes,the dude got skills,and he's a good guy to deal with,my bike pulls hard bottom to top,so if you live in the area don't have any reservations about using him,trust me.He has a Eddy current dyno with a Air/Fuel sniffer, which enables you to hold the bike at 10,20,30,ect. percent throttle openings and fine tune the entire rev range A/F ratio,all the numbers were standard numbers with a weather station software correcting the numbers automatically to what your bike would put out at optimum conditions.I never had my bike on a Eddy current dyno before but after watching him tune at every throttle opening I would not use any other type dyno in my opinion,my bike is like a stocker as far as drivability goes.Thanks Lewe for giving me my money's worth.