Squirts You need to get the #1 piston up on compression stroke,you can do this two way's 1 ratchet on balancer or have a friend tap the starter while you stick a finger over #1 spark plug hole. When you feel compression make them stop taping. Take your ratchet and bring piston up to t.d.c. (line on balancer to 0 on timing tab) then pull distributor cap stright up rotor should be pointing to #1 spark plug wire. Oh #1 on a B.B.Chevy is the front clyn. on driver's side, If rotor point's to #1 spark plug wire you can start takeing her apart! Step's to take, drain coolent, pull top rad hose off, unhook throttle linkage and fuel lines, temp wire, pull distributor&wire's out the way, intake bolts and your there! post your progress and i'll take you through the next step!