SuzukiHayabusa.org
TECHNICAL => GEN II BUSA => Topic started by: knecum on December 11, 2009, 11:56:50 PM
-
Before i remove it does a arm made for a 1000 go on a gen 2 as far as the pivot shaft size and arm width ? thanks
-
well,i think the pivot size will be ok,but the arm will be to narrow,i remember making spacers to fit a 01 600 arm on that bike,and i think you need .090/side on the pivot....and seeing the gen1/2 frames are the same,i dont see why not...
-
all i had to do is use the busa sleeve inside the arm because busa pivot shaft is bigger...thanks
-
where did you get the sleeves from?
-
where did you get the sleeves from?
sleeve !!! it came out of his stock arm i took off!