SuzukiHayabusa.org
TECHNICAL => HELP! => Topic started by: roscoerf on May 04, 2012, 08:07:26 AM
-
i INSTALLED A NEW CLUTCH IN MY 04 BUSA AND IT SLIPS AS IT APPROCHES THE POWERBAND I INSTALLED 3 HEAVYER SPRINGS AND IT WORKS WELL BUT THE CLUTCH EFFORTS ARE HIGH.
HOW DO I MAKE BETTER ?
-
stack hieght is very important, you can not just throw a clutch in
-
How do you measure stack height ?
-
Dial caliper
-
Trac king clutches come with the stack heights already set. :tu: :tu: http://aperaceparts.com/mailers/trackingclutches.html
-
stack hieght is very important, you can not just throw a clutch in
if the stack height is not right then how is it adjusted to the right height??? i always though that if u installed a complete new clutch that u were good to go
-
Min 1.98" thicker steel plates