SuzukiHayabusa.org
TECHNICAL => GEN II BUSA => Topic started by: JSpin on October 22, 2013, 07:59:42 PM
-
I need some help fellas. I am wanting to put my set of gen 2 busa BST's on a 2013 abs model. I have not seen an abs model in person, so I dont know how the wheels speed sensor(s) are installed. If they are on the wheel, then I know the answer is a simple "no". I seem to recall someone saying the sensors were in the brake rotors, and if thats the case, the wheels should be a 1 for 1 swap.
any info is appreciated!
-
abs rings are bolted in side the rotor around the wheel bearing. shouldn't be to hard to make a mount to put on carbon wheel. make an aluminum flange to bolt ring to and epoxy it to the wheel. :tu:
-
thank you very much, thats the exact info i needed.