SuzukiHayabusa.org

TECHNICAL => ALL MOTOR TALK => Topic started by: 6 inch over on April 26, 2017, 09:30:11 PM

Title: Carpenter tune
Post by: 6 inch over on April 26, 2017, 09:30:11 PM

Run it or get my bike dyno

Title: Re: Carpenter tune
Post by: RansomT on April 27, 2017, 10:07:40 AM

??  A little more info....

Title: Re: Carpenter tune
Post by: 6 inch over on April 28, 2017, 01:33:52 AM

Built by Bob
PC 3 tune by Bob
1397 et street bike

Title: Re: Carpenter tune
Post by: Bim28 on April 28, 2017, 07:01:19 AM

Get it turned.

Title: Re: Carpenter tune
Post by: blt1 on April 28, 2017, 10:32:09 AM

Why tune something that should already have a good tune in it, appears Bob tuned it when he had it.

Title: Re: Carpenter tune
Post by: RansomT on April 28, 2017, 01:24:13 PM

If Bob had the bike at his shop and tuned it, then it should be o.k.   Since it has a PC3, I assume it was an older build, then if that is the case I would have it at least checked on the dyno.

Title: Re: Carpenter tune
Post by: 6 inch over on April 28, 2017, 09:09:52 PM

It needs tuning to fat I think

Title: Re: Carpenter tune
Post by: RansomT on April 29, 2017, 09:56:59 AM

The older builds Bob tuned with MR9, which would be way fat with anything but MR12. Also, there isn't a bike that I have worked with that doesn't at least need a touch up on the MAP after a few years.