SuzukiHayabusa.org
TECHNICAL => HELP! => Topic started by: vinny e on April 23, 2018, 11:26:55 AM
-
1441 build would .039 measured squish (average of 2 pieces of solder)7 be to tight?
-
Are you referring to plastigauge ? Like main bearing gap ?. Please be more specific . If it is, neither rods, nor mains should have a .039" "squish.". Try .0010-.0020 on mains, and .0020-.0025 on rods. That's the range I used. I was told not to use plastigauge. Measure everything with a micrometer, and bore gauge until you get the gap you're looking for. Good luck !.
A.
-
Hey Vinny,
Just read your other post. All good. Good luck !.
A.