SuzukiHayabusa.org
TECHNICAL => HELP! => Topic started by: 08BusaD500 on June 04, 2018, 03:29:43 PM
-
I have a 03 with a brocks cushion kit and a slave support, my clutch fibers and steels are fine but my lever is going limp. Nothing appears to be leaking . If I have my clutch lever adjustment wheel in the 1 position the clutch barely disengages before the bar, if I have it in 2-6 position it will not disengage at all. I have bled the lower bleeder twice and it helped for a couple squeeses of the lever. I haven't opened up clutch hydraulic system so I don't know how/if air is the cause. Any help or advice would be greatly appreciated.
-
Probably it's time to rebuild (or at least clean) master/slave cylinders and replace brake fluid there. Pay attention at ports in master cylinder that connect brake fluid reservoir and piston chambers, there must be no gunk.
-
Thanks for the reply Thomas, I cleaned it thoroughly and it seems to be functioning properly, going to the track Sunday so I'll find out for sure. Thanks again
-
have you measured your clutch stack height?