SuzukiHayabusa.org
TECHNICAL => ALL MOTOR TALK => Topic started by: on March 30, 2003, 08:27:00 PM
-
Can anyone tell me the best way to replace the clutch pushrod seal? Can it be done without splitting the cases? (http://images/smiles/icon_confused.gif)
-
SPLIT THE CASES (http://images/smiles/converted/yes.gif)
-
it can be done with out splitting the cases. But i would not do it to my bike>you have to grind the ceases a little pull out the seal and replace with a new one and then goop a bunch of silicon on there
-
There was someone a while back from, I believe, Arizona who had a neat little deal you used to keep all the crud out of the clutch slave cylinder. I'd think you could possibly use one of those and put a seal under it - over the original one. Someone may remember who it was that had them.
-
people were using a 2 liter pop bottle cap
-
The bottle cap will work for keeping the crud out but I don't think it will work very well as a seal.
-
Here you go..... (http://pub31.ezboard.com/fazbiketechfrm10.showMessage?topicID=1.topic)
Regards,
SJJBusa
-
I CUT A SEAL DOWN AND SILICONE IT OVER THE OLD 1