Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Anyone tried VP113?  (Read 1204 times)

Offline gnd111

  • Post Apocalyptic Whore
  • ********
  • Posts: 12410
  • Fried Chicken and Gasoline...
Anyone tried VP113?
« on: September 09, 2007, 02:10:09 PM »
It is same octane as C12 but it is Oxygenated.  $47 for a 5gal pail.  A guy on my FZ1 board used it for his lastet tune session and his bike only has 12.5 c/r and absolutely loved this stuff...
Logged

Offline Competitive Edge Racing Cylinder Heads

  • Mad Post Whore
  • ******
  • Posts: 2285
  • Gender: Male
  • We Makem Go-Fast!!!!
Re: Anyone tried VP113?
« Reply #1 on: September 09, 2007, 04:38:04 PM »
 :thumb: :thumb:   Eric thats What Ive Been Running for 2yrs............ Except for my last Few Trips on Last Motor??????? Rann Mr moto 113 first yr  then Vp made this 113 & you Know ive Been Spraying!!!!!!  :thumb: :thumb:
Logged
Official Site Shop
New best 6.87 @ 193 MPH    

Offline gnd111

  • Post Apocalyptic Whore
  • ********
  • Posts: 12410
  • Fried Chicken and Gasoline...
Re: Anyone tried VP113?
« Reply #2 on: September 09, 2007, 06:52:46 PM »
Cool.  Never even heard it discussed before and this guys low C/R FZ1 made the same RWHP on VP113 as it did on U4.  I am going to get me some VP113 this week... :thumb:
Logged

Offline xquizitzx10

  • Post Whore
  • ****
  • Posts: 578
  • Gender: Male
  • Live life as if it was your last!!
Re: Anyone tried VP113?
« Reply #3 on: September 10, 2007, 09:43:10 AM »
GOOD STUFF 4SURE :thumb: :thumb:
Logged

CARPENTER POWERED!!
HAYS PERFORMANCE!!
MTC ENGINEERING!!
UNDERPRESSURE!!
$$GETSUM$$
Pages: [1]   Go Up
« previous next »