input needed on a wet system

[dg-gsx1300r]

I want to spray over 200hp.  The Motor has been built with all the best parts to handle it.  I have a NX system with  the nozzles installed in the head and a Holley blue for fuel
I also already have
NOS 5 dial progressive controller
EFIR-13 Retard Module
Power Commander III USB
WOT switch

What nitrous parts do I need? solenods? nozzles ? jets?
what fuel should I run?
is the power commander up to the task?

thanks

Dave

[badassblackbusa]

 if you already have a nx kit why would you need more solenoids and jets. i prefer the nos over the nx but its all personal preference. i would run c-25. you need to pull 16 degrees of timing at wot. make sure your petcock and fuel pump will support the amount of fuel needed for that much nos. power commander will be ok. that big of a shot i hope the motor is really well built or its not going to last long. jc