2008 ECTA Motorcycle Rulebook Corrections

[narider]

2008 ECTA Rulebook
If yours is not correct (a small amount went out before being corrected), please add the following corrections to the motorcycle section of your rulebook as follows.

Correction 1
7.C.2 Leathers:(Page 74): In sentence 3, strike through the word metal to read as follows.

7.C.2 Leathers:
Leathers certified by a recognized manufacturer to be suitable for the application are required. One-piece suits or two-piece suits zippered together are allowed. Required over 175 MPH: One-piece leathers or two-piece leathers with full (270 degree) metal zipper. Also required over 175 MPH: Special protective armor, as produced by a recognized manufacturer, with minimum coverage at elbows, knees, shoulders, hips and back. Undergarments having the required armor coverage are acceptable, when the undergarment is worn with the required leather suit.


Correction 2
7.J.14 Engine Diplacement Classes:(Page 83): In sentence 2, add 50 and 3000 cc classes, and change the 3000+ reference to 3001+ to read as follows.

7.J.14 Engine Displacement Classes:
Engine Classes are shown in cubic centimeters. 50, 100, 125, 175, 250, 350, 400 (ECTA Only) , 500, 650, 750, 1000, 1350, 1650, 2000, 3000 and 3001+ where permitted.

Please pass this info on to any ECTA racers you are affiliatted with, especially concerning the metal zipper not being needed in case there are those purchsing new suits and trying to meet htis requirement.
Thanks,
Todd

PS: If you do not have your rulebook yet (or don't have it handy) and would like to reference the above, you can do so at this address.
http://twinjugsracing.com/ecta08mcrules.htm