Haybusa Parts and Service Member Support

Author Topic: setting shift light...............  (Read 2937 times)

Offline ANTDOG600

  • Mad Post Whore
  • ******
  • Posts: 2395
  • Gender: Male
setting shift light...............
« on: May 25, 2008, 07:48:16 AM »
 :thumb:

Offline ANTDOG600

  • Mad Post Whore
  • ******
  • Posts: 2395
  • Gender: Male
Re: setting shift light...............
« Reply #1 on: May 26, 2008, 08:16:47 PM »
i had the instructions, but lost them.....

Offline Shamrock

  • Post Apocalyptic Whore
  • ********
  • Posts: 10171
  • Gender: Male
    • Shamrock Racing


Offline sliceman1300

  • Rider
  • ***
  • Posts: 84
Setting shift light instructions
« Reply #3 on: June 14, 2008, 05:43:25 AM »
Press and hold the SEL button and turn on the ignition switch and hold for a further 2 seconds or more.

Press the ADJ button to change the light mode (light-blink-no light-light)

Press the SEL button to advance to light brightness selection showing 0 00 000 0000 00000 in the odometer display. Use the ADJ button to select.

Press the SEL button to advance to RPM set and again set using the ADJ button the press SEL to fix the setting.

Hope this helps, Jim

Offline poboybusa

  • Rider
  • ***
  • Posts: 23
  • Gender: Male
Re: setting shift light...............
« Reply #4 on: June 18, 2008, 05:48:18 PM »
begin with plenty of time and patience and possibly a stiff drink. after reading the instructions repeat stiff drink , after a few attempts, order one from boost- by -smith