FI light

[plat03busa]

Will having a small box mod done on a Bone stock Busa trigger the FI light? No power commander, stock exhaust.

[LeasingGuy]

No, but why do the air box mod with no pipe or PC? I can guarantee you it will run worse.

[plat03busa]

I know. Put together a salvaged title busa and the air box was missing so I used my old air box I had laying around before turbo. I have a constant FI light. I think maybe one of the local guys sold me an air box sensor for a GSXR 1000. Dunno

[LeasingGuy]

whats the code?

[plat03busa]

been a long time..How do i get the code again?

[LeasingGuy]

Take a piece of wire or a paperclip and jump the two wires in the service plug. Its on the left (shifter) side of the tail section and may have a rubber boot covering the connector.

Turn the key on, when the FI light is on jump the wires. It will flash "C" codes where the clock is located.   

[plat03busa]

thanks Bro..will do 

[plat03busa]

-C 13 is the code

[LeasingGuy]

Ya, the MAP sensor. Place a post in the wanted section, the turbo guys will have one sitting on a shelf. They replace them with a 3 bar sensor. Trust me, you dont want to buy one new $$$$$. If you have a buddy with a Busa try his 1st but unless the vacuum line is disconnected or hooked up wrong or its not plugged up to the harness, you'll need a new one.

[plat03busa]

  I have one some where. The 1 that came off my turbo bike, I think I gave it to a board member. thanks again for the info.