Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Gen 1 swing arm and Gen 2  (Read 6003 times)

Offline LQN4U

  • Rider
  • ***
  • Posts: 229
  • Gender: Male
Gen 1 swing arm and Gen 2
« on: July 08, 2008, 01:25:48 AM »
are they the same?
Logged
06 LE
Yosh TRS Dual outlet exhaust
BMC Race Filter
PC3 usb,
Dynojet ignition module
air box mod,
40 Shot NX Exp
braided steel brake/clutch lines
pazzo shorties
Carrozerria wheels

Offline Shamrock

  • Post Apocalyptic Whore
  • ********
  • Posts: 10171
  • Gender: Male
    • Shamrock Racing
Re: Gen 1 swing arm and Gen 2
« Reply #1 on: July 08, 2008, 08:51:06 AM »
Quote from: LQN4U on July 08, 2008, 01:25:48 AM
are they the same?
Well Kinda. They use the same pivot bolts , the rear caliper and rotor set up is diffrent you would have to use the gen 1 rear rim,Rotor, Brake hanger,Caliper hope that helps
Logged

Offline 06stocker

  • Rider
  • ***
  • Posts: 186
  • Gender: Male
  • Speed Kills
Re: Gen 1 swing arm and Gen 2
« Reply #2 on: July 10, 2008, 08:26:17 PM »
So if i put a o6 swing arm on a 08 i can use my PM wheels on it..Right?
Logged

Offline unit176

  • Post Whore
  • ****
  • Posts: 986
  • Gender: Male
  • Bigger is better!
Re: Gen 1 swing arm and Gen 2
« Reply #3 on: July 10, 2008, 08:32:33 PM »
the swingarms are interchangeable, but you have to use the entire set up...wheel brakes, etc...
Logged

Offline E-RACER

  • Universal Post Whore
  • *******
  • Posts: 9408
Re: Gen 1 swing arm and Gen 2
« Reply #4 on: July 10, 2008, 10:12:09 PM »
Or just weld a slot on the inside to hold the caliper hanger..

I did this on My 1000 when I installed a 600 arm..
Logged

Offline Shamrock

  • Post Apocalyptic Whore
  • ********
  • Posts: 10171
  • Gender: Male
    • Shamrock Racing
Re: Gen 1 swing arm and Gen 2
« Reply #5 on: July 10, 2008, 11:23:30 PM »
Dont forget about front wheel spacing and rotor Sizing  :P
Logged

Offline ACE23

  • Mad Post Whore
  • ******
  • Posts: 2081
Re: Gen 1 swing arm and Gen 2
« Reply #6 on: July 12, 2008, 08:07:00 PM »
I was told by Dave at TRACDYNAMICS that the gen 1 fits the gen 2 but their is modifications that need to be done to get the bearings to fit
Logged
RCC SUPER ULTRA
Race fuel=XXXHP / XXXTQ
93 oct= XXXHP / XXXTQ
Motor by Cooper Performance
Tranny by R&D
Controlled by NLR
Monitored by AEM
Resurrected by Murderedout
Tuned by "........"
=Youtube Interstate Pulls
Pages: [1]   Go Up
« previous next »