Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Wiring Question  (Read 2249 times)

Offline WarBusa

  • Rider
  • ***
  • Posts: 64
  • Gender: Male
  • Where am I?
Wiring Question
« on: July 26, 2008, 08:30:56 PM »
I just finished wiring my zex dry system with a window switch and WOT switch with a relay.  On the relay I have the white from the window switch to the 86 post, the ground to the 87 post, the power to the 85 post and the solenoid to the 30 post. The way zex says to connect it. The question is... I have continuous power to the 30 pole of the solenoid. Is that normal and will it draw power from the battery??
Logged

Offline jasonsbusa

  • Post Whore
  • ****
  • Posts: 670
  • Gender: Male
Re: Wiring Question
« Reply #1 on: July 26, 2008, 11:06:43 PM »
I replied to your pm :thumb:
Logged

Offline jasonsbusa

  • Post Whore
  • ****
  • Posts: 670
  • Gender: Male
Re: Wiring Question
« Reply #2 on: July 27, 2008, 09:34:39 AM »
You shouldnt have power at post 30.When the window switch sends out the ground to post 86 it grounds pin 30 and activates the solenoid.Test the relay to make sure it is good.That is probably your problem.If it is bad replace it then take a jumper wire and ground post 86 to the battery and the solenoid open making a clicking sound.
Logged
Pages: [1]   Go Up
« previous next »