Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: help needed  (Read 1626 times)

Offline qic

  • Apprentice Post Whore
  • **
  • Posts: 5
help needed
« on: December 01, 2008, 04:29:38 PM »
my box with my valve shim felt of my hands and now all the shim is laying around, i have the following measure 262 and 282
wich one is going to intake and wich one to exaust,can some one help me
Logged

Offline Stocker64

  • Post Whore
  • ****
  • Posts: 888
  • Gender: Male
Re: help needed
« Reply #1 on: December 01, 2008, 04:53:27 PM »
try installing them and measureing the lash,then compare the measurements with suggested factory spefications.
Logged
09 BUSA, PROBLEMCHILD II.... tuned with the factory ecu by ME!! thanks PETRIK, ridgeracer,and SMITHBUSA. ...  "FAMILY FIRST"...

Offline GeorgeC

  • Mad Post Whore
  • ******
  • Posts: 4985
  • Gender: Male
  • It sucks to be slow...
Re: help needed
« Reply #2 on: December 02, 2008, 07:43:47 AM »
Yep, no way to tell where they go without putting them in and measuring...  :(
Logged

Offline Pinky

  • HO HO
  • Restricted
  • Mad Post Whore
  • ******
  • Posts: 4737
  • Gender: Male
Re: help needed
« Reply #3 on: December 02, 2008, 08:07:39 AM »
id start with trying the thicker ones on the intake side and then measure and swap from there (the intake has a tighter tolerance)
Logged
T70 turbo w/ 60mm wastegate
Megasquirt EFI

Offline crazybill

  • Mad Post Whore
  • ******
  • Posts: 4220
    • www.PortTechHeads.com
Re: help needed
« Reply #4 on: December 02, 2008, 08:20:37 AM »
yes the 282 will go on the intake side and 262 on the exhaust if all is factory spec . I would still bench shim the head before installation .

I bet you just wanted to start kicking stuff huh...  :lol:
Logged
“Nobody can be so amusingly arrogant as a builder who has just discovered an old idea and thinks it is his own.”
Pages: [1]   Go Up
« previous next »