Author Topic: Output Shaft Support Kit for k8 (Read 3919 times) Tweet

jkumpu · « **on:** March 06, 2009, 02:46:56 PM »

Hi,

Any idea how much power transmission output shaft can take whit out Output Shaft Support Kit ?

In what power shaft start bend and slow down top speed ?

Who makes them for k8 ?

Cookie · « **Reply #1 on:** March 06, 2009, 03:07:11 PM »

The GenII output shaft is beefed up over GenI shafts, so your getting a much better shaft.

How much horsepower are you trying to build here?

Cookie · « **Reply #2 on:** March 06, 2009, 03:15:48 PM »

Brock offers this kit

Brock's Billet Output Shafts

jkumpu · « **Reply #3 on:** March 11, 2009, 01:06:31 PM »

I looking for 250-260 Hp whit out turbo or nitrous.

I think that shaft will hold ok, but There might be some bending to the gearbox, which is no good for top speed.

Cookie · « **Reply #4 on:** March 12, 2009, 01:43:02 PM »

http://www.suzukihayabusa.org/forum/index.php?topic=137920.0;topicseen

Jay · « **Reply #5 on:** March 21, 2009, 11:30:19 AM »

I think he was asking about the Output Shaft

Cookie · « **Reply #6 on:** March 24, 2009, 01:19:29 PM »

Quote from: Jay on March 21, 2009, 11:30:19 AM

I think he was asking about the Output Shaft

My bad. Thanks, Jay.

That shaft is essential to a proper build!

News:

Author Topic: Output Shaft Support Kit for k8 (Read 3919 times) Tweet

jkumpu

Output Shaft Support Kit for k8

Cookie

Re: Output Shaft Support Kit for k8

Cookie

Re: Output Shaft Support Kit for k8

jkumpu

Re: Output Shaft Support Kit for k8

Cookie

Re: Output Shaft Support Kit for k8

Jay

Re: Output Shaft Support Kit for k8

Cookie

Re: Output Shaft Support Kit for k8