Anyone use EE2 on a Gen2 for nitrous yet?

[Adrnlnjunky]

*** POSTING THIS HERE AS WELL AS IN TUNING/LOGGING***

Just seeing if anyone has successfully used the EE2 on a Gen2 for nitrous. If so, what was your setup and results? 

[smithabusa]

not that i am aware of, there is no rpm based output yet to actually trigger it, but doing map switching wouldn't be hard, easiest way would be to just add a toggle switch ($4 at radio shack) to the map switching wire, then pull timing out of ms ignition map, and add fuel to the ms tps map, and away you go    On a dyno of course...

[PetriK]

The gen1 relay + horn button or lights flash button activation should work particularly when using the schematic that includes a diode.

[Stocker64]

*** POSTING THIS HERE AS WELL AS IN TUNING/LOGGING***

Just seeing if anyone has successfully used the EE2 on a Gen2 for nitrous. If so, what was your setup and results? 

I have not used it for fueling on ms1,but i have took timing out of my mso map sucessfully.....wet kit....,made 305 hp...