Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Cluster problems?  (Read 4908 times)

Offline 559hp

  • Apprentice Post Whore
  • **
  • Posts: 8
Cluster problems?
« on: December 03, 2009, 11:38:49 PM »
Does any body now how to reset the cluster? I change the light bulbs inside the cluster and now me needle for rpm is in 1000 and the mph is on 10.
Thanks
Logged

Offline Cookie

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 9875
  • I'VE UPPED MY STANDARDS ,,, SO UP YOURS!
Re: Cluster problems?
« Reply #1 on: December 03, 2009, 11:57:01 PM »
You can reset the pointer by following the these instructions; from the service manual -

1) With the function switch (lower middle- above trip/odometer) pressed, turn the ignition switch on.
2) Release the function switch, 3 to 5 seconds afer turning the ignition switch on.
3) Press the function switch twice (within one second). :arrow: Reset
* Complete the operation within 10 seconds after the ignition switch has been turned on.

Let know how that works for you.
Logged
-Chris

גַּבְרִיאֵל guide me to the light ישוע המשיח

Offline 559hp

  • Apprentice Post Whore
  • **
  • Posts: 8
Re: Cluster problems?
« Reply #2 on: December 09, 2009, 09:17:04 AM »
Thank you.
It really works.
Logged

Offline Cookie

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 9875
  • I'VE UPPED MY STANDARDS ,,, SO UP YOURS!
Re: Cluster problems?
« Reply #3 on: December 10, 2009, 02:53:53 AM »
Good to know you got it! Happy Holidays!  :thumb:
Logged
-Chris

גַּבְרִיאֵל guide me to the light ישוע המשיח
Pages: [1]   Go Up
« previous next »