Haybusa Parts and Service Member Support

Author Topic: 05 1000 arm on a gen 2  (Read 3893 times)

Offline knecum

  • Mad Post Whore
  • ******
  • Posts: 2092
  • Gender: Male
  • The Recipe!
    • www.knecumpower.com
05 1000 arm on a gen 2
« on: December 11, 2009, 11:56:50 PM »
Before i remove it does a arm made for a 1000 go on a gen 2 as far as the pivot shaft size and arm width ? thanks

Offline Canadian Mike

  • Mad Post Whore
  • ******
  • Posts: 3528
Re: 05 1000 arm on a gen 2
« Reply #1 on: December 12, 2009, 07:54:31 AM »
well,i think the pivot size will be ok,but the arm will be to narrow,i remember making spacers to fit a 01 600 arm on that bike,and i think you need .090/side on the pivot....and seeing the gen1/2 frames are the same,i dont see why not...

Offline knecum

  • Mad Post Whore
  • ******
  • Posts: 2092
  • Gender: Male
  • The Recipe!
    • www.knecumpower.com
Re: 05 1000 arm on a gen 2
« Reply #2 on: December 19, 2009, 09:19:12 AM »
all i had to do is use the busa sleeve inside the arm because busa pivot shaft is bigger...thanks

Offline Kamikazek9

  • Rider
  • ***
  • Posts: 269
  • Gender: Male
Re: 05 1000 arm on a gen 2
« Reply #3 on: January 18, 2010, 03:30:51 AM »
where did you get the sleeves from?
SPEED---- Gotta Have IT !!!!

Offline knecum

  • Mad Post Whore
  • ******
  • Posts: 2092
  • Gender: Male
  • The Recipe!
    • www.knecumpower.com
Re: 05 1000 arm on a gen 2
« Reply #4 on: January 21, 2010, 08:18:14 AM »
where did you get the sleeves from?

sleeve !!! it came out of his stock arm i took off!