Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: spark plug question ?????  (Read 5577 times)

Offline busadon71

  • Rider
  • ***
  • Posts: 184
spark plug question ?????
« on: March 12, 2010, 11:35:04 AM »
hayabusa and other bikes use ngk cr9e plugs which are 5K ohm resistanse correct?

what if any advantage is there to go to a non resistor type plug and can one be used on the busa coil pack with no damage and if it can be used, can you use it with nitrous also

Thanks for any help or comments
Logged
S.B. Racing of Bossier
Local racing parts supplier

Offline busadon71

  • Rider
  • ***
  • Posts: 184
Re: spark plug question ?????
« Reply #1 on: March 13, 2010, 03:29:21 PM »
Anybody somebody !!!!!!!!
Logged
S.B. Racing of Bossier
Local racing parts supplier

Offline FlatlandBusa

  • OFF TOPIC
  • Mad Post Whore
  • **********
  • Posts: 2606
  • Gender: Male
  • -John- Middleofnowhere, Nebraska
Re: spark plug question ?????
« Reply #2 on: March 13, 2010, 07:51:57 PM »
The resistance of the plug really doesn't matter as long as the internal resistance is lower than that of the spark plug gap.

Do not run non-resistor plugs.  They make a lot of electrical noise, and do strange things with the ecu sensors and electronics.
Logged
"You can not escape the responsibility of tomorrow by evading it today."
-Abraham Lincoln

Offline 396

  • Mad Post Whore
  • ******
  • Posts: 2549
  • Gender: Male
Re: spark plug question ?????
« Reply #3 on: March 24, 2010, 09:57:31 PM »
I ran non resistors. Bike ran fine, but they made my kill box act weird. Stick with resistors.
Logged
Pages: [1]   Go Up
« previous next »