OK gentlemen had a 1300 now its a 1397 new pistons rods crank. nothing done to the head just cleaned and adjusted valves transmission had some gears that were bad through 400.00 into it all new gaskets of coarse new water pump mech didn't like the looks of other one i think he said it just spun to fast i told him if there's doubt get rid of it. going to put a in line water pump and oil cooler on also. Now this is going back into a mini sandrail one seater weighs approx.1300 lbs. so ? is how should i go about breaking this engine in its going to be dam near all new and where's a good place to mount the inline water pump? closer to rad ? how far away can i mount the oil cooler ? should i mount it high or low ? anyhelp would be nice
