Haybusa Parts and Service Member Support

Author Topic: FI LIGHT on non busa gauges available now...  (Read 2533 times)

Offline PetriK

  • ECU Guru
  • Post Master
  • *****
  • Posts: 1035
  • Gender: Male
  • Where am I?
FI LIGHT on non busa gauges available now...
« on: July 24, 2010, 01:13:10 PM »
The MIL light may be interesting to you guys running AIM or any other advanced racing gauge clusters.

Basically now after some tweaking with ecueditor.com you can hook up a bright LED to your gauge cluster wire and run it in FI light only mode. It operates the same way (starts to illuminate) when an DTC/FI errorcode is detected. It turns off when power is turned off - but the best thing is that the errorcodes that turned the FI light on are stored in the ecu memory and can be read and cleared afterwards with e.g. ecueditor.com or Suzuki SDS unit - even when the power has been off from the engine for a while.



http://www.activeboard.com/forum.spark?aBID=99460&p=3&topicID=37242894

Online Yngve

  • Post Master
  • *****
  • Posts: 1765
  • Gender: Male
Re: FI LIGHT on non busa gauges available now...
« Reply #1 on: July 24, 2010, 01:50:06 PM »
So no I have no excuses for not putting the GEN II ECU on my Gen I Hayabusa... :)
I dont know what I am talking about but I do know that I am right :)