Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Gen 2 cam specs  (Read 6612 times)

Offline livewire

  • Apprentice Post Whore
  • **
  • Posts: 15
  • Gender: Male
Gen 2 cam specs
« on: October 25, 2010, 07:49:39 AM »
Greetings all.
Can some-one please tell me the specs on gen 2 busa cams?
At 1mm/ .040", thanks
Cheers,
G
Logged

Offline TurboGen2

  • Post Whore
  • ****
  • Posts: 959
  • Gender: Male
  • Molon Labe
Re: Gen 2 cam specs
« Reply #1 on: October 25, 2010, 10:25:34 AM »
Logged
When injustice becomes law, Resistance becomes DUTY! -Thomas Jefferson

Offline livewire

  • Apprentice Post Whore
  • **
  • Posts: 15
  • Gender: Male
Re: Gen 2 cam specs
« Reply #2 on: October 25, 2010, 02:05:26 PM »
Thanks bloke,
.3 mm lift! Them's odd figures.
Any-one help with figures at 1mm/ .040"?
« Last Edit: October 25, 2010, 02:08:20 PM by livewire »
Logged

Offline livewire

  • Apprentice Post Whore
  • **
  • Posts: 15
  • Gender: Male
Re: Gen 2 cam specs
« Reply #3 on: October 26, 2010, 02:04:20 AM »
Intake Valve Timing   
 Open BTDC  43 degrees
 Close ABDC  58 degrees
 Duration  281 degrees

 Exhaust Valve Timing   
 Open BBDC  62 degrees
 Close ATDC  24 degrees
 Duration  266 degrees

 Valve Timing Measuring Point  0.3 mm.

Actually, them's really odd figures.
Centerline inlet: 97.5 degrees, exhaust 109 degrees
« Last Edit: October 26, 2010, 02:30:06 AM by livewire »
Logged
Pages: [1]   Go Up
« previous next »