I have a 09 busa ecu on a 06 gix loom (on an 01 1k), needed about 15 wires moved in the plug ,currently have the bike cranking, not firing, but that's with the 2 wire 01 cam sensor,my 07 gix cam sensor i think arrives today ,and i may get time to fit it and see if i can get the bike to run ,
Currently the editor dash shows only my temp sensors faulting , there not connected, but it also shows no rpm, which i associate with no proper cam signal , was 1/2 expecting rpm from the crank sensor and a cam sensor fault but i suppose with the 2 wire sensor connected it thinks there is a sensor connected but cannot recognise the signal
Originally i was just going to use the 06 ecu on my 01 to be able to set limiters,injector size ,etc as this bike has an AEM piggyback and otherwise works well
once provan this will transfer to my landspeed 99 750 that is currently running a 01 1k loom and ecu and microtech secondaries