Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Gearing for gen2 turbo  (Read 1825 times)

Offline turbojonn

  • OFF TOPIC
  • Mad Post Whore
  • **********
  • Posts: 3147
  • Friends don't let friends use boost.
Gearing for gen2 turbo
« on: February 16, 2011, 11:57:59 PM »
If I want to go as fast as possible with 350 hp how should I gear it? How about with 400 hp? It will be 4-6 over.
Logged
RCC turbos rock!!! Rcc- Ultra plenum, case saver, Carillo rods, Wossner pistons, APE springs/tool steel shift shafts, Ferrara valves, ARP studs, lightened and balanced crank, Boostbysmith ecu editor, AMS 1000 with CO2, 475 hp. Mac arm 0-6 over, BST carbon fiber rims. Someday I'm goin' fast!

Offline JHerheim

  • Mad Post Whore
  • ******
  • Posts: 2432
  • Gender: Male
Re: Gearing for gen2 turbo
« Reply #1 on: February 17, 2011, 08:47:43 AM »
Obviously the biggest front and smallest rear you could fit.   :D



Oh,  you probably mean at a venue that has a limited surface.  In that case there will be lots of variables.   Personally I'd start 19 40 and buy 38-45 to play with.
Logged
Pages: [1]   Go Up
« previous next »