custom nitrous lines

[firemanjim]

Doing a hidden install on a monster motor HD Bagger and need some custom lines made,. I used a place in Socal about 6 years ago but forget the name now,any recommendations? Need 90 degree ends to fit into the tight area of intake manifold on the dang V-twin.

[Gixx1300R]

Can u post a pic of where you need the lines to go?

[Johnnnycheese]

try this place

http://www.sweetperformance.com/product/index.php?act=viewProd&productId=345

[TRNorBRN6001]

No doubt, Sweet Performance is the place to go. In house custom stuff for a good price! No China stuff, no middle man, no distributor, no out sourcing..................you talk to him you get it done by him! I think he is in Cali too.

[firemanjim]

All I saw was brake lines??? And I notoced on the lines I have here that the end going to the nitrous nozzle because the jet goes there must have lots of threads and the brake lines I looked at did not and the amount of material in the taper area was lacking for a good seal it seemed.

[KerrdoggRPS]

If you look at it the jet becomes the 37* flare for the fitting so there should be enough material to make a good seal. If you need help directly I stock Fragola and carry almost every length line in stock, I also offer discounts to fellow board members in thanks to all the info I have learned here, you can reach me at 561-375-6277 www.racepartsolutions.com