Haybusa Parts and Service Member Support

Author Topic: Temp Sensor mod for fan switch  (Read 5174 times)

Offline GSXRTURBO1

  • OFF TOPIC
  • Post Master
  • **********
  • Posts: 1830
Temp Sensor mod for fan switch
« on: December 12, 2002, 12:39:00 PM »
On another thread I brought up that I did this modification. Someone asked for the part number, but I didn't have it handy then. Here goes:

This part bolts right in the stock Suzuki temp sensor for the fan, but it turns the fan on 10* C cooler. The only problem is it uses different connectors. You can either get the plug end from a wrecked Honda Accord, or do as I did. I took small female blade type connectors and spliced them into the stock wires (you have to cut off the Suzuki plug end). I then filled the well of the connector with silicone to keep vibration from being a factor. I also used the stock black "boot" to make it look like it came that way from the factory.

The part is from a Honda Accord, the part number is 37760-P00-003

This is courtesey of Peter Anderson from Anderson Turbo, he posted this part number quite awhile back.

I think cost was under $40
Thomas

Offline DaveO

  • Legacy Rider
  • Mad Post Whore
  • *
  • Posts: 2490
Temp Sensor mod for fan switch
« Reply #1 on: December 13, 2002, 10:31:00 AM »
Thomas,

Good stuff, Thanx!

Dave
220.312 at Maxton...ALL MOTOR

www.NewLimitsTuning.com

OFFICIAL SITE SPONSOR