Haybusa Parts and Service Member Support

Author Topic: Kawasaki ZX6R, woodacraft rearset swap, now rear brake drags. adjust actuator?  (Read 1637 times)

Offline speed_pigeon

  • Post Master
  • *****
  • Posts: 1285
  • Gender: Male
  • South Florida, West Palm Beach
so basically I have a 2000 ZX6R. the right foot peg bracket was broken, welded and broke again. I bought a set of woodcraft rearsets and to install and adjust the right foot peg, I had to compress the rear brake slave cylinder actuator. I cannot, for the life of me, find an adjustment to allow me to compensate for the compression. the rear bake is about 80% compressed and there is little to no travel left in the brake lever. it is still at a low angle, but before the adjustment it was pointing at the ground. can someone give some insight here? I have searched high and low and cannot find anything but a suggestion that I cut the actuator pin... there has to be a better way. thanks.
The Pigeonmobile!