What did I do wrong??

[moparict]

[TT]

is that the front sprocket?? the pic is kinda big

[moparict]

Yup.  It ate up my speed sensor which surprisingly still works.

[mrultra1300r]

is the bolt still tight? if so do you have a 30mm output shaft?

[moparict]

is the bolt still tight? if so do you have a 30mm output shaft?

Bolt is torqued correctly and I do have the HD output shaft.

[moparict]

Anybody?

[TT]

ok, give us a little more info, did it break while u were riding or did it break while u were hitting it with ur hammer??

[dadofthree]

You have two damaged parts there brother. Look closely at the nut on the output shaft. It is cracked and missing a section that probably put the hurt on the pick up coil.

[BusaBD]

When I installed my hd shaft and aftermarket billet cover had to space the sensor out some with a few 10/32 washers

[Mike-Nightrider]

I had the same issue a few years ago.
Perhaps it was only a little stone etc.... picked up from the chain who caused that damage.
Ive installed a new sensor and never had that problem again 



PS:
The idea from BusaBD with the washers sound good 
So the gap is a little bit bigger and small pieces of dirt can pass...

[mrultra1300r]

the reluctor doesn't sit down in the output shaft like it does the stock one thus putting it to close to the sensor. if you have a bench grinder you can grind down the outside diameter of the shoulder that goes into the shaft it will work fine.

[moparict]

the reluctor doesn't sit down in the output shaft like it does the stock one thus putting it to close to the sensor. if you have a bench grinder you can grind down the outside diameter of the shoulder that goes into the shaft it will work fine.

Thanks

[moparict]

When I installed my hd shaft and aftermarket billet cover had to space the sensor out some with a few 10/32 washers

I'm going to try that also.

[speedduck]

What year is your bike ?

[moparict]

07 gen1

[mysticblu999]

I had to grand my speed rotor down before it would fit. Grind it flush.

Sent from my SAMSUNG-SGH-I717 using Tapatalk 2

[speedduck]

07 gen1

Ok, 07 rotor should fit Robinson HD-shaft, both are 13mm(.51"). But if you have older rotor, between 99-03, or even later, it is 14mm(.55") and it won`t fit inside HD-shaft, the bolt tightens it but it stays about 5mm out. Gen2 is also wrong size, 16mm(.63").