Haybusa Parts and Service Member Support

Author Topic: 1441 nitrous dry build question  (Read 9113 times)

Offline Isleofmanbusa

  • Rider
  • ***
  • Posts: 43
  • Gender: Male
  • Enthusiast
1441 nitrous dry build question
« on: March 11, 2014, 01:44:10 PM »
I have just started my 1441 dry build and a quick question how far down the hole do I want the pistons I will be using a 100 shot of nitrous ,thay are heavy duty cp pistons made for nitrous ,I thaught abought 40" down the hole is this correct or am I way off ,hope some one can help
My mind is a scary place

Offline RansomT

  • Post Master
  • *****
  • Posts: 1221
  • Gender: Male
Re: 1441 nitrous dry build question
« Reply #1 on: March 11, 2014, 02:34:14 PM »
Static Compression?

Typically, on a moderate compression piston, you would want somewhere around a 40 thousands quench area, which includes the thickness of the head gasket.
Fastest 1.5-Mile Pass - 252.222
Fastest 1-Mile Pass - 244.2997
Half Mile - 211.47
Fastest Nitrous Bike
Production Bike
211.079 LTA. P/P 1350

Offline Redline103

  • Apprentice Post Whore
  • **
  • Posts: 13
Re: 1441 nitrous dry build question
« Reply #2 on: March 24, 2014, 11:20:28 AM »
Putting the piston in the hole .040 would give you around .070 quench which would have you giving up a lot of HP on motor for no good reason. I would recommend you go with the advise above which will give you a better all around combo.  :tu:

Offline Isleofmanbusa

  • Rider
  • ***
  • Posts: 43
  • Gender: Male
  • Enthusiast
Re: 1441 nitrous dry build question
« Reply #3 on: April 29, 2014, 05:18:15 PM »
Spot on thanks for help motor now built and for a mild compression motor made good power 219 bhp 127 ftlbs of torque now for the nitrous
My mind is a scary place

Offline C_Henry

  • Post Whore
  • ****
  • Posts: 925
  • Gender: Male
Re: 1441 nitrous dry build question
« Reply #4 on: February 06, 2017, 02:24:56 PM »
I know this is a old posts but, how did this turn out ?
Now , Knecum powered . Fire in tha hole !