Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Decking a block?  (Read 3857 times)

Offline talegria

  • Rider
  • ***
  • Posts: 115
Decking a block?
« on: August 20, 2014, 09:02:23 PM »
Can I Deck the surface of a Gen 1 block to clean up small imperfections without hurting the nikasil in the bores? I know the cylinders are coated with nikasil but is the surface of the block coated also?
« Last Edit: August 20, 2014, 10:08:10 PM by talegria »
Logged

Offline sportbikeryder

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 7352
  • Gender: Male
Re: Decking a block?
« Reply #1 on: August 21, 2014, 06:42:57 AM »
The surface isn't coated, but you have to be careful not to chip the bores.
Logged
Any day on a motorcycle like this that ends just needing parts and labor is a good day.
4.82, 158.67mph 1/8th mile 7.350, 200.32mph 1/4 mile Riding

4.392, 176.79mph 1/8th mile  6.610, 228.15mph 1/4 mile Tuning

Offline Competition CNC

  • Rider
  • ***
  • Posts: 483
    • CompetitionCNC.com
Re: Decking a block?
« Reply #2 on: August 21, 2014, 02:39:51 PM »
Yes you can resurface it.  You need to use a PCD cutter on the machine and "prep" the cylinder before putting it on the machine.  We do them all the time.
Logged
Jim

Offline talegria

  • Rider
  • ***
  • Posts: 115
Re: Decking a block?
« Reply #3 on: August 21, 2014, 03:42:05 PM »
Quote from: Competition CNC on August 21, 2014, 02:39:51 PM
Yes you can resurface it.  You need to use a PCD cutter on the machine and "prep" the cylinder before putting it on the machine.  We do them all the time.
what would you charge me to do one?
Logged

Offline Competition CNC

  • Rider
  • ***
  • Posts: 483
    • CompetitionCNC.com
Re: Decking a block?
« Reply #4 on: August 27, 2014, 06:36:49 AM »
Give us a call at 860-274-0631   thanks
Logged
Jim
Pages: [1]   Go Up
« previous next »