Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Gen II bike with Gen I engine  (Read 3620 times)

Offline RdRcr150

  • Apprentice Post Whore
  • **
  • Posts: 14
  • Gender: Male
Gen II bike with Gen I engine
« on: September 06, 2014, 08:25:10 AM »
Installed built Gen I engine in Gen II frame. Stock wire harness. All electrics in good condition, all switches, relays, and all connectors required for running connected.  Fully charged battery and all fuses good. Turn key on...nothing. Connect test light to turn signal relay ground and turn kill switch to off and dash lights illuminate with all digital numbers reading 8. We have changed the cam position sensor to one from MPS. Grounds checked good. We have power to main switch and all connectors that should have power, do have power. Any ideas?
« Last Edit: September 06, 2014, 08:26:57 AM by RdRcr150 »
Logged

Offline moparict

  • Post Whore
  • ****
  • Posts: 737
Re: Gen II bike with Gen I engine
« Reply #1 on: September 06, 2014, 09:04:15 AM »
What do you mean by "turn key on, nothing".  No lights, no starting, no fuel pump prime? 
Logged

Offline RdRcr150

  • Apprentice Post Whore
  • **
  • Posts: 14
  • Gender: Male
Re: Gen II bike with Gen I engine
« Reply #2 on: September 06, 2014, 09:26:17 AM »
Power to all red and otherwise powered sources, but dash only lights up if you turn kill switch off. Horn doesn't horn, starter motor only spins if I jump solenoid. I am really confused as to why all the numbers on the digital dash read 8.
« Last Edit: September 06, 2014, 09:29:13 AM by RdRcr150 »
Logged
Pages: [1]   Go Up
« previous next »