Haybusa Parts and Service Member Support

Author Topic: Sb6 2 step & nitrous  (Read 1521 times)

Offline Hard 90

  • Apprentice Post Whore
  • **
  • Posts: 8
  • Enthusiast
Sb6 2 step & nitrous
« on: December 17, 2014, 11:09:27 PM »
I'm trying to figure out how to wire my nitrous so it does not work while on the 2 step using a sb6. I had it wired with a 4 pin relay & the bike would not come off the 2 step with the relay hookup. So went back to the drawing board & wired up a 5 pin relay to activate a 4 pin relay & it feed back to the sb6 box again causing the bike to lose 10 hp on the dyno.

Offline GSXRTURBO1

  • OFF TOPIC
  • Post Master
  • **********
  • Posts: 1806
Re: Sb6 2 step & nitrous
« Reply #1 on: January 05, 2015, 03:16:00 PM »
give a solid state relay a try if you haven't already. Cheaper relays use "points" that can lose connection (open and close the circuit when you don't want it to) caused by vibration. Just a thought...
Thomas

Offline firemanjim

  • Authorized Tuner
  • Post Whore
  • ***
  • Posts: 794
Re: Sb6 2 step & nitrous
« Reply #2 on: February 03, 2015, 11:55:41 PM »
Thanks for the wonderful advertisement------
Official Site Tuner
www.jtsperformance.com
Home of one of the fastest 750cc bikes in the world
239MPH faired, 209MPH naked!
Bonneville 200 Club
El Mirage 200 Club
Mojave Mile 200 Club
Mojave Magnum 200 Club
NEDRA 100 MPH Club
Gairdner 200MPH Achiever 2013
2014 1st place Mojave Mile N/A bike
2015 top speed trophy at WOS
Colorado mile 200 MPH club
2017 DLRA 200 MPH club