Haybusa Parts and Service Member Support
« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Ceramic Bearings..................  (Read 45797 times)

Offline Busashot

  • Post Master
  • *****
  • Posts: 1121
Re: Ceramic Bearings..................
« Reply #25 on: October 09, 2015, 09:26:48 PM »
When everything else has been done, I did them and like them. Although my bike does everything well especially cornering, it was worth it for that.
« Last Edit: October 09, 2015, 10:16:43 PM by Busashot »
Logged

Offline Ghost-Geezer

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 7531
  • Gender: Male
  • Older But Still Sexy
Re: Ceramic Bearings..................
« Reply #26 on: October 14, 2015, 03:23:15 PM »
I did not notice a significant difference when I put the ceramics in my stock rims initially..............but, I had to ride the bike about 250 miles to let the balls and the races like each other more............after that 250...............everything bedded in and I could feel a significant change, especially when rolling the bike up onto the lift.  Easy peasy.  If they work in the garage, they work on the street, IMO.  It seemed to be a bit "snappier" when whacking the throttle in third and 4th at 5500 or so.   :tu:
« Last Edit: October 14, 2015, 03:25:12 PM by Ghost-Geezer »
Logged
"The thrill of Boost cannot be duplicated on earth."

"One drink is too many and a thousand is not enuf."

"Step UP or Step Aside"

"Four wheels moves the body,
Two wheels moves the soul."
Pages: 1 [2]  All   Go Up
« previous next »