Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Need info on stock head with aftermarket cams  (Read 4933 times)

Offline getmissn

  • Rider
  • ***
  • Posts: 87
  • Where am I?
Need info on stock head with aftermarket cams
« on: March 18, 2015, 11:57:09 PM »
Been running stock head on Gen 1 bus a with Yosh stg1 cams. Wondering if I could pick up some horsepower by swapping my Yosh intake for a Web 378 n moving my yosh intake to the exhaust side?. THANKS
Logged

Offline getmissn

  • Rider
  • ***
  • Posts: 87
  • Where am I?
Re: Need info on stock head with aftermarket cams
« Reply #1 on: March 21, 2015, 12:30:53 PM »
Someone out there  has got to have some helpful info.
Logged

Offline 1vapors

  • Rider
  • ***
  • Posts: 298
Re: Need info on stock head with aftermarket cams
« Reply #2 on: July 15, 2015, 04:18:27 PM »
this is the genII section might try the genI section
Logged

Offline knecum

  • Mad Post Whore
  • ******
  • Posts: 2092
  • Gender: Male
  • The Recipe!
    • www.knecumpower.com
Re: Need info on stock head with aftermarket cams
« Reply #3 on: July 16, 2015, 08:21:20 AM »
You could do that, done expect to feel alot,  I would  pull the head and mill it .013.  Thin HG @ .018 not worth smacking  the head for.
Logged

Offline Jeremyg1283

  • Rider
  • ***
  • Posts: 78
  • Enthusiast
Re: Need info on stock head with aftermarket cams
« Reply #4 on: December 01, 2015, 11:32:24 AM »
Quote from: getmissn on March 18, 2015, 11:57:09 PM
Been running stock head on Gen 1 bus a with Yosh stg1 cams. Wondering if I could pick up some horsepower by swapping my Yosh intake for a Web 378 n moving my yosh intake to the exhaust side?. THANKS

did you ever change this setup?
Logged
Pages: [1]   Go Up
« previous next »