ALL UNREAD TOPICS
1/2" or 7/16" inches in diameter for cylinder studs??
Numbers do not lie. But, having said that, it takes a whole lot of skill and money to make it happen. My hat is off to Joey/APE......Notice the loaded roller on the drive chain. Smart.
Quote from: Ghost-Geezer on November 25, 2015, 08:28:45 PMNumbers do not lie. But, having said that, it takes a whole lot of skill and money to make it happen. My hat is off to Joey/APE......Notice the loaded roller on the drive chain. Smart. No TURBO either . . .
Quote from: Ghost-Geezer on November 27, 2015, 08:12:16 PM1/2" or 7/16" inches in diameter for cylinder studs??1/2
Yeah he does Red, think he's just using a Vance & Hines collector instead of the dump out the side.