Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: Busa engine mounts  (Read 3779 times)

Offline Beaty

  • New User!
  • *
  • Posts: 1
  • Enthusiast
Busa engine mounts
« on: February 20, 2016, 01:21:25 PM »
I'm a noob in the sport bike engine category so please forgive if I ask some seemingly dumb questions. I'm considering transplanting a Busa engine into a sibe-by-side.

Do all Busa engines have the same mounting provisions. For instance, could I take a 99 Busa engine and install it easily into a current Busa or visa versa? I'm aware internals, tuning etc. are probably not interchangeable. I'm just talking about the bolt up.

Any info about interchangeability for these engines would be greatly appreciated.
« Last Edit: February 20, 2016, 01:24:21 PM by Beaty »
Logged

Offline LVBUSA

  • OFF TOPIC
  • Rider
  • **********
  • Posts: 261
Re: Busa engine mounts
« Reply #1 on: February 24, 2016, 07:39:50 AM »
99-07, yes. Anyone got Gen II input ?
Logged
Amsoil Synthetics / Race Ready Painted Inner Panels / Bagster Tank Protector & Tank Bags / Hump Mod / ZG Double Bubble / Mirror Spacers / +1/2" dogbones / EK ZZZ 530 / Michelin Pilot Road 5's / TL 1000R Pegs / EBC HH Pads / Corbin Saddles /

Offline STREETDRAG

  • Rider
  • ***
  • Posts: 175
  • Enthusiast
Re: Busa engine mounts
« Reply #2 on: February 24, 2016, 10:44:25 AM »
the motors are pretty much swaps. the issue is you have to shim gen 2 motor over in gen1 chassis cause of tranny shaft.. 99-16, bolt up wise same... going in side by side just line up sprockets on direct drive.. if running through differential then set the two up to mate inline...
Logged
Pages: [1]   Go Up
« previous next »