Haybusa Parts and Service Member Support

Author Topic: Help motor swap!!!!  (Read 3364 times)

Offline Bam750gsxr

  • Apprentice Post Whore
  • **
  • Posts: 13
  • Gender: Male
  • Boost Enthusiast
Help motor swap!!!!
« on: February 25, 2017, 11:34:05 PM »
 I recently swap my k3 750 motor for a rebuilt one. Everything went smoothly except now bike won't start fuel pump will prime but starter won't kick on I'm getting c11 and c12 code which is crankshaft position sensor and can shaft position sensor. I changed both sensors still getting the same codes. Please help
2x2=4
If you have everything under control, your not moving fast enough

Offline Stainless1

  • Rider
  • ***
  • Posts: 419
  • Gender: Male
Re: Help motor swap!!!!
« Reply #1 on: February 26, 2017, 11:09:44 AM »
The starter not turning the motor has nothing to do with those sensors.  They only work when the motor is spinning.  Apply 12v to the starter motor, if motor spins look at starter solenoid, button and wiring, if it does not ck starter with 12v after you remove it.  if it spins motor is stuck.... if it doesn't starter is bad...
Let us know what you find
« Last Edit: February 26, 2017, 06:17:43 PM by Stainless1 »
Bonneville 200 MPH Club
245 MPH Turbo Busa Powered Lakester
208.959 MPH NA GSXR 1000

Offline Bam750gsxr

  • Apprentice Post Whore
  • **
  • Posts: 13
  • Gender: Male
  • Boost Enthusiast
Re: Help motor swap!!!!
« Reply #2 on: February 26, 2017, 01:38:12 PM »
Thank you for your response I will let you know
2x2=4
If you have everything under control, your not moving fast enough