Ok, so this may get complicated.
I've had this harness on 2 bikes before now with the PMR handlebar switch.
The best I can remember........the switch is off, the bike ran on motor map just fine.
The switch is on, we're spraying. I have NEVER used the mode buttons on any bike I've had. Always throttle position and RPM activated it.
NOW fast forward to my 3rd harness on my new bike. Toggle switch is on, plug in the pig tail to the orange wire and it sprays upon desired RPMs and throttle position.
That's option #2....
Option 2: Have Toggle Switch in the On Position (requires 1 wire splice near ECU connector) / Window RPM / Wide Open Throttle
Turn the switch to the off position and the ecu still enriches as if it were spraying.
Now, on the first bike I was only spraying a 40 dry shot, so I guess I could of been enriching thru the ECU even with the bottle turned off and it wasn't enough to notice, but the second bike I was spraying an 80 dry shot. I would think that if it was telling the ECU to give me fuel and the bottle was off, it would have hurt my performance.
What am I missing here??
If it's going to spray with the on/off switch in either position, what's it used for?