Haybusa Parts and Service Member Support

Author Topic: Motec M130 ECU and C127 Display Setup  (Read 112 times)

Offline jjckflsh

  • Rider
  • ***
  • Posts: 105
  • Gender: Male
  • Where am I?
Motec M130 ECU and C127 Display Setup
« on: June 09, 2017, 05:59:47 PM »
Hi Jack Here,

Anybody have experience with the setup on a Motec M130 ECU and C127 Display?  Trying to configure for the street part of riding.  Specifically, The inputs for the Speedometer, Fuel Level, Left and Right Turn indicators, High Beam Light, Odometer being displayed on C127.  Looking for how you wired the inputs CAN or Direct wiring,  From ECU or direct from sensor.  Ect.  Just trying to get some ideas on how to do it, any problems that have to be addressed etc. I have 2004 with supercharger.

Thanks for any imput!

Jack
« Last Edit: June 09, 2017, 06:01:18 PM by jjckflsh »

Online sportbikeryder

  • OFF TOPIC
  • Universal Post Whore
  • **********
  • Posts: 7220
  • Gender: Male
Re: Motec M130 ECU and C127 Display Setup
« Reply #1 on: June 11, 2017, 11:47:46 AM »
Use CAN from the motec. No need to double wire.
Any day on a motorcycle like this that ends just needing parts and labor is a good day.
4.82, 158.67mph 1/8th mile 7.350, 200.32mph 1/4 mile Riding

4.51, 171.75mph 1/8th mile  6.908, 212.83mph 1/4 mile Tuning