Haybusa Parts and Service Member Support

Author Topic: Squish  (Read 266 times)

Offline vinny e

  • Apprentice Post Whore
  • **
  • Posts: 7
Squish
« on: April 23, 2018, 11:26:55 AM »
1441 build  would .039 measured squish (average of 2 pieces of solder)7 be to  tight? 

Offline LVBUSA

  • OFF TOPIC
  • Rider
  • **********
  • Posts: 247
Re: Squish
« Reply #1 on: April 28, 2018, 09:12:24 AM »
Are you referring to plastigauge ? Like main bearing gap ?. Please be more specific . If it is, neither rods, nor mains should have a .039" "squish.". Try .0010-.0020 on mains, and .0020-.0025 on rods. That's the range I used.  I was told not to use plastigauge.  Measure everything with a micrometer, and bore gauge until you get the gap you're looking for. Good luck !.

A.
Amsoil Synthetics / Race Ready Painted Inner Panels / Bagster Tank Protector & Tank Bags / Hump Mod / ZG Double Bubble / Mirror Spacers / Custom Fairing Grills / +1/2" dogbones / EK ZZZ 530 / Michelin Pilot Road 3's / TL 1000R Pegs / EBC HH Pads /

Offline LVBUSA

  • OFF TOPIC
  • Rider
  • **********
  • Posts: 247
Re: Squish
« Reply #2 on: May 16, 2018, 08:32:46 AM »
Hey Vinny,

       Just read your other post. All good. Good luck !.

A.
Amsoil Synthetics / Race Ready Painted Inner Panels / Bagster Tank Protector & Tank Bags / Hump Mod / ZG Double Bubble / Mirror Spacers / Custom Fairing Grills / +1/2" dogbones / EK ZZZ 530 / Michelin Pilot Road 3's / TL 1000R Pegs / EBC HH Pads /