TECHNICAL > ALL MOTOR TALK
Squish
vinny e:
Building 1441 and one of my piston squish mesurement comes out @ .039. (Used 2 pieces of solder and averaged them ). Would this be to tight???
B.Eskedal:
No
I use 0.8mm (032) on my 1441 with stock rods.
vinny e:
Thank you I’m a tad paraanoid
RansomT:
But the better question would be what is your PTV clearance?
vinny e:
Thanx for the heads up, next measurement, built it last time tight but had issues (wasn’t nice on street). Only race once or twice a year so trying to make it nicer for street.. found out what all race motor ment!
Navigation
[0] Message Index
[#] Next page
Go to full version