Haybusa Parts and Service Member Support

Author Topic: Looking for help on a gen 1 stock internals  (Read 2511 times)

Offline 08BusaD500

  • Rider
  • ***
  • Posts: 57
  • Enthusiast
Looking for help on a gen 1 stock internals
« on: February 13, 2019, 08:04:47 PM »
I have a stock motor gen1, I would like to attempt to pick up some power. I recently bought a second intake cam for it. I've been told to put a thinner head gasket in it to bump up the compression a touch. I was planning on slightly porting the head, mostly remove casting marks and clean it up a bit. I also have a performance first cycle dry spray bar in it with a lazy 40 shot, bad tune, tuned through ecu editor. I plan on having it dyno tuned. I drag race it one weekend a month and street ride it weekly.

Not really sure what I should run for cam timing?
Is a .018" gasket ok?
I also have a set of 47 lb valve springs I thought I would put in it.
What are guys spraying in a stock gen1, 50hp-60hp? opening up ring gaps?

Any advice would be appreciated.

Offline Red

  • Post Master
  • *****
  • Posts: 1325
  • Gender: Male
    • http://www.revival.tv
Re: Looking for help on a gen 1 stock internals
« Reply #1 on: February 15, 2019, 04:32:03 PM »
1999 Prostar West Super Gas Champion !
2000 NMRA / Prostar Pro E/T runner up.
2001, 2002, & 2003 NMRA Pro E/T Champion !
2004 #3, 2005, & 2006 NMRA Pro E/T runner up.
2007 Pro. St. Legal #6, NMRA Pro E/T Champion !
2008 MDRA Super Streetbike Champion !