Haybusa Parts and Service Member Support
« previous next »
Pages: [1]   Go Down

Author Topic: What pins do I jump in the connector in the tail to read FI fault codes  (Read 2148 times)

Offline po boy

  • Post Whore
  • ****
  • Posts: 890
What pins do I jump in the connector in the tail to read FI fault codes
« on: January 30, 2021, 07:20:14 AM »
05 Busa. FI light is on.Been so long since I did it, I can't remember the way to use a paper clip to take the place of Suzuki's 'special tool' on the connector in the tail.
Logged

Offline RansomT

  • Post Master
  • *****
  • Posts: 1219
  • Gender: Male
Re: What pins do I jump in the connector in the tail to read FI fault codes
« Reply #1 on: January 30, 2021, 08:56:12 AM »
In the 4 pin molex, there are only 2 wires connected.  Just bridge those.
Logged
Fastest 1.5-Mile Pass - 252.222
Fastest 1-Mile Pass - 244.2997
Half Mile - 211.47
Fastest Nitrous Bike
Production Bike
211.079 LTA. P/P 1350

Offline po boy

  • Post Whore
  • ****
  • Posts: 890
Re: What pins do I jump in the connector in the tail to read FI fault codes
« Reply #2 on: January 30, 2021, 09:15:34 AM »
Thank you. As soon as I read that I remembered there's only 2 wires. Been 15 years since I looked at one, lol.
Logged

Offline TT

  • OFF TOPIC
  • Post Master
  • **********
  • Posts: 1524
Re: What pins do I jump in the connector in the tail to read FI fault codes
« Reply #3 on: February 11, 2021, 12:20:29 PM »
install a permanent  micro toggle switch & hide / mount it in the tail somewhere so all you need to did is flip the switch to get codes
Logged
alcohol is the cause and solution to all my problem,s

it burn,s when i pee

tattoos and harley,s  both image enhancers
Pages: [1]   Go Up
« previous next »