Haybusa Parts and Service Member Support

Author Topic: Weird running issue  (Read 212 times)

Offline firemanjim

  • Post Whore
  • ****
  • Posts: 903
  • Gender: Male
    • Black Art Racing
Weird running issue
« on: October 21, 2021, 02:22:27 PM »
 A good running 2006 1397 , I just had engine out and added the APE Gen 2 crank, ran great before. Now it acted like rev limiter and went flat at upper rpm, threw C-24 and C-27 codes. Plugs looked good, swapped coils --no change, swapped ecu--no change--- ran coils off separate relay-- no change, swapped stator and crank sensor-- no change, pulled cam sensor and it revs way better but still throws those same codes, will let it cool off then pull cam cover to check cam timing and pin height.
Any input??
Official Site Tuner

Home of one of the fastest 750cc bikes in the world
239MPH faired, 209MPH naked!
Bonneville 200 Club
El Mirage 200 Club
Mojave Mile 200 Club
Mojave Magnum 200 Club
NEDRA 100 MPH Club
Gairdner 200MPH Achiever 2013
2014 1st place Mojave Mile N/A bike
2015 top speed trophy at WOS
Colorado mile 200 MPH club
2017 DLRA 200 MPH club
2018 Shift Sector 200 MPH Club

Online RansomT

  • Post Master
  • *****
  • Posts: 1204
  • Gender: Male
Re: Weird running issue
« Reply #1 on: October 22, 2021, 06:45:58 AM »
I hate when this crap happens. Remember you are dealing with a bike that has a wiring harness that is more than 15 years old.  However, since you pulled the cam sensor and it reved better AND threw the same codes.  Like you are doing, I would check the cam timing...Intake that goes above 112, will act like that.  I personally would have swapped the cam sensor before pulling the cam cover, but it probably wouldn't have changed the problem.
Fastest 1.5-Mile Pass - 252.222
Fastest 1-Mile Pass - 244.2997
Half Mile - 211.47
Fastest Nitrous Bike
Production Bike
211.079 LTA. P/P 1350