1st gen busa -- Cluster gauge not working (speedo - tachometer - gas gauge - temperature) just a couple of green idiot lights on. I resetted and cleaned the plug. Fuse is good but still doesn't work. ENGINE RUNS!
I measured the resistance of the sending unit wire and there is +5 volts but the gauge needle don't work.
Question --> If the accessories (such as signal, stop, high beam, brake light, horn etc.etc.etc), are not connected,
WILL THE CLUSTER GAUGE WORK or will it not work?
I don't know what else to do except buy another cluster gauge, maybe the cluster gauge I bought from ebay is bad?
Thank you
