Haybusa Parts and Service Member Support

Author Topic: strokers and rods  (Read 15680 times)

Offline elc

  • Rider
  • ***
  • Posts: 84
strokers and rods
« Reply #25 on: April 28, 2003, 07:13:00 PM »
i have checked the crush on a few rods and it will scare you when you see what it is
Lee Cunningham
BSM

Offline Steve A

  • Universal Post Whore
  • *******
  • Posts: 9155
  • Gender: Male
strokers and rods
« Reply #26 on: April 28, 2003, 07:18:00 PM »
OK - scare me.  

THEMOTORHEAD

  • Guest
strokers and rods
« Reply #27 on: April 28, 2003, 07:34:00 PM »
also remember this
bearings work harden
they are under heat and pressure
after a small amount running time they become harder
break it in without poundonmg it allowing em to harden helps alot!!
and detinations the biggest culprit
oil and pressure just help counter act dum shit

Offline VC22348

  • Rider
  • ***
  • Posts: 267
strokers and rods
« Reply #28 on: April 30, 2003, 08:26:00 PM »
Dennis: Chief BrokenRod here. What kind of performance or lack of can one expect from broken rods??????????????????          

Offline DaveO

  • Legacy Rider
  • Mad Post Whore
  • *
  • Posts: 2490
strokers and rods
« Reply #29 on: April 30, 2003, 08:48:00 PM »
90% of spun rod brgs in Busa's are either #1 or #2. Coincidence?? Hardly, they share the same oil feed, where all the others have dedicated feeds.

I think you guys can do the rest of the math....nuff said.

Dave
220.312 at Maxton...ALL MOTOR

www.NewLimitsTuning.com

OFFICIAL SITE SPONSOR